Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Suffix:
<ip>
Parameters:
<State>
INPut<ip>:UPORt[:VALue]
This command queries the control lines of the user ports.
For details see
Suffix:
<ip>
Return values:
<Level>
Example:
10.8.5.2
Working with power sensors
The following commands describe how to work with power sensors.
These commands require the use of a Rohde & Schwarz power sensor. For a list of
supported sensors, see the data sheet.
The [Sensor] connector is provided by the "Additional Interfaces" option R&S FPL1-B5.
Additionally, the power sensor measurement requires the option R&S FPL1-K9.
●
Configuring power sensors
●
Configuring power sensor measurements
Configuring power sensors
SYSTem:COMMunicate:RDEVice:PMETer<p>:CONFigure:AUTO[:STATe]
SYSTem:COMMunicate:RDEVice:PMETer<p>:COUNt?
SYSTem:COMMunicate:RDEVice:PMETer<p>:DEFine
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
1 | 2
irrelevant
ON | 1
User port is switched to INPut
OFF | 0
User port is switched to OUTPut
*RST:
1
OUTPut<up>:UPORt[:VALue]
1 | 2
irrelevant
bit values in hexadecimal format
TTL type voltage levels (max. 5V)
Range:
#B00000000 to #B00111111
INP:UPOR?
//Result: #B00100100
Pins 5 and 7 are active.
........................................................................................... 787
Remote commands
on page 806.
.................................................................. 789
........................... 788
......................................................... 788
.......................................................... 788
793
793
Publicité
