Rohde & Schwarz FPL1000 Manuel D'utilisation page 687

®
R&S FPL1000
//------------ Checking the Results-------------------------
//Query the result of the limit check for all ranges.
CALC:LIM:FAIL?
//Query the peak for each range of the SEM measurement as a list.
TRAC:DATA? LIST
10.6.8 Measuring spurious emissions
The following commands are required to perform spurious emissions measurements.
●
Initializing the measurement
●
Configuring a sweep list
●
Configuring the list evaluation
●
Adjusting the X-axis to the range definitions
●
Performing a spurious measurement
●
Retrieving and saving settings and results
●
Programming example: spurious emissions measurement
10.6.8.1 Initializing the measurement
Note that with the R&S FPL1000, the spurious measurement must be initialized before
you can start configuring the sweep list or list evaluation.
INITiate<n>:SPURious
INITiate<n>:SPURious
This command initiates a Spurious Emission measurement.
Suffix:
<n>
10.6.8.2 Configuring a sweep list
The following commands configure the sweep list for spurious emission measure-
ments.
The sweep list cannot be configured using remote commands during an on-going
sweep operation.
Useful commands for configuring the sweep described elsewhere:
●
[SENSe:]SWEep:MODE
Remote commands exclusive to spurious measurements:
[SENSe:]LIST:RANGe<ri>:BANDwidth:RESolution
[SENSe:]LIST:RANGe<ri>:BANDwidth:VIDeo
[SENSe:]LIST:RANGe<ri>:BREak
[SENSe:]LIST:RANGe<ri>:COUNt?
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
......................................................................................... 681
................................................................................................ 681
...................................................................................... 689
.......................................................................... 692
............................................................................................................. 681
on page 653
......................................................................... 682
........................................................................................... 683
......................................................................................... 683
Remote commands
.............................................................. 692
................................................................. 692
..................................... 692
................................................................. 682
687 687