Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Suffix:
<n>
<w>
<t>
Parameters:
<ScalingType>
Example:
Manual operation:
10.8.4
Configuring triggered and gated measurements
The commands required to configure a triggered or gated measurement in a remote
environment are described here.
The tasks for manual operation are described in
uration",
*OPC should be used after requesting data. This will hold off any subsequent changes
to the selected trigger source, until after the sweep is completed and the data is
returned.
●
Configuring the triggering conditions
●
Configuring gated measurements
10.8.4.1
Configuring the triggering conditions
The following commands are required to configure a triggered measurement.
TRIGger[:SEQuence]:DTIMe
TRIGger[:SEQuence]:HOLDoff[:TIME]
TRIGger[:SEQuence]:IFPower:HOLDoff
TRIGger[:SEQuence]:IFPower:HYSTeresis
TRIGger[:SEQuence]:LEVel[:EXTernal<port>]
TRIGger[:SEQuence]:LEVel:IFPower
TRIGger[:SEQuence]:LEVel:IQPower
Manuel d'utilisation 1179.5860.09 - 12
Window
subwindow
Trace
LOGarithmic
Logarithmic scaling.
LINear
Linear scaling in %.
LDB
Linear scaling in the specified unit.
PERCent
Linear scaling in %.
*RST:
DISP:TRAC:Y:SPAC LIN
Selects linear scaling in %.
See
"Scaling"
on page 339.
................................................................................................... 778
Setting basic spectrum RF measurement parameters
LOGarithmic
on page 323
Chapter 6.7, "Trigger and gate config-
........................................................................... 777
................................................................................ 782
..................................................................................... 778
.................................................................................. 778
............................................................................. 779
........................................................................ 779
...................................................................................... 779
...................................................................................... 780
Remote commands
783
783
Publicité
