Rohde & Schwarz FPL1000 Manuel D'utilisation page 832

®
R&S FPL1000
10.8.7.3 Using trace mathematics
The following commands control trace mathematics.
CALCulate<n>:MATH<t>[:EXPRession][:DEFine]
CALCulate<n>:MATH<t>:MODE
CALCulate<n>:MATH<t>:POSition
CALCulate<n>:MATH<t>:STATe
CALCulate<n>:MATH<t>[:EXPRession][:DEFine] <Expression>
This command selects the mathematical expression for trace mathematics.
Before you can use the command, you have to turn trace mathematics on.
Suffix:
<n>
<t>
Parameters:
<Expression>
Example:
Manual operation:
CALCulate<n>:MATH<t>:MODE <Mode>
This command selects the way the R&S FPL1000 calculates trace mathematics.
Suffix:
<n>
<t>
Parameters:
<Mode>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
................................................................... 826
.............................................................................................. 826
.......................................................................................... 827
.................................................................................................... 827
Window
irrelevant
(TRACE1-TRACE2)
Subtracts trace 2 from trace 1.
(TRACE1-TRACE3)
Subtracts trace 3 from trace 1.
(TRACE1-TRACE4)
Subtracts trace 4 from trace 1.
(TRACE1-TRACE5)
Subtracts trace 5 from trace 1.
(TRACE1-TRACE6)
Subtracts trace 6 from trace 1.
CALC:MATH:STAT ON
Turns trace mathematics on.
CALC:MATH:EXPR:DEF (TRACE1-TRACE3)
Subtracts trace 3 from trace 1.
See "Trace Math Function"
Window
irrelevant
For more information on the way each mode works see
Math Mode.
LINear
Linear calculation.
Remote commands
on page 428
Trace
832 832