Rohde & Schwarz FPL1000 Manuel D'utilisation page 646

®
R&S FPL1000
Parameters:
<State>
<State>
Manual operation:
CALCulate<n>:LIMit<li>:ACPower:ACHannel[:RELative] <LowerLimit>[,
This command defines the relative limit of the adjacent channels. The reference value
for the relative limit is the measured channel power.
If you have defined an absolute limit as well as a relative limit, the R&S FPL1000 uses
the lower value for the limit check.
Suffix:
<n>
<li>
Parameters:
<LowerLimit>
<UpperLimit>
Manual operation:
CALCulate<n>:LIMit<li>:ACPower:ACHannel:RESult?
This command queries the state of the limit check for the adjacent channels in an
ACLR measurement.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
Manuel d'utilisation 1179.5860.09 - 12
ON | OFF | 1 | 0
Absolute limit check for lower adjacent channel
*RST:
ON | OFF | 1 | 0
Absolute limit check for upper adjacent channel
*RST:
See "Limit Check"
<UpperLimit>]
irrelevant
irrelevant
The limit of the lower adjacent channel.
Range:
*RST:
Default unit: dB
The limit of the upper adjacent channel.
Range:
*RST:
Default unit: dB
See "Limit Check"
INITiate<n>:CONTinuous
irrelevant
Configuring and performing measurements
0
0
on page 146
0 dB to 100 dB
0 dB
0 dB to 100 dB
0 dB
on page 146
on page 620.
Remote commands
646 646