Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Parameters:
<Frames>
Example:
Manual operation:
CALCulate<n>:SGRam:FRAMe:SELect <Frame> | <Time>
CALCulate<n>:SPECtrogram:FRAMe:SELect <Frame> | <Time>
This command selects a specific frame for further analysis.
The command is available if no measurement is running or after a single sweep has
ended.
Suffix:
<n>
Parameters:
<Frame>
<Time>
Example:
Manual operation:
CALCulate<n>:SGRam:HDEPth <History>
CALCulate<n>:SPECtrogram:HDEPth <History>
This command defines the number of frames to be stored in the R&S FPL1000 mem-
ory.
Suffix:
<n>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
The maximum number of frames depends on the history depth.
Range:
1 to history depth
Increment: 1
*RST:
1
//Select single sweep mode
INIT:CONT OFF
//Set the number of frames to 200
CALC:SGR:FRAM:COUN 200
See
"Frame Count"
on page 337
Window
Selects a frame directly by the frame number. Valid if the time
stamp is off.
The range depends on the history depth.
Default unit: S
Selects a frame via its time stamp. Valid if the time stamp is on.
The number is the distance to frame 0 in seconds. The range
depends on the history depth.
INIT:CONT OFF
Stop the continuous sweep.
CALC:SGR:FRAM:SEL -25
Selects frame number -25.
See
"Select Frame"
on page 337
Window
Remote commands
826
826
Publicité
