Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
●
[SENSe:]CORRection:METHod
●
[SENSe:]CORRection[:STATe]
Remote commands exclusive to power sweeps:
SOURce<si>:POWer:MODE
SOURce<si>:POWer:STARt
SOURce<si>:POWer:STOP
SOURce<si>:POWer:MODE <Mode>
Enables or disables a power sweep.
Suffix:
<si>
Parameters:
<Mode>
Example:
Manual operation:
SOURce<si>:POWer:STARt <StartLevel>
Defines the start power level of the internal generator signal for power sweeps. This
value must be lower than the stop level (see
on page 803).
Suffix:
<si>
Parameters:
<StartLevel>
Example:
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
on page 800
on page 799
.................................................................................................... 802
.................................................................................................... 802
..................................................................................................... 803
irrelevant
FIXed | SWEep
FIXed
Fixed power level. Required for tracking generator.
SWEep
Increasing power level. Required for power sweep.
*RST:
FIXed
SOUR:POW:MODE:SWE
SOUR:POW:STAR -50
SOUR:POW:STOP -10
See
"Power Sweep"
on page 104
See
"Usage"
on page 299
SOURce<si>:POWer:STOP
irrelevant
Range:
-60 to +10
*RST:
-30
Default unit: DBM
SOUR:POW:MODE:SWE
SOUR:POW:STAR -50
SOUR:POW:STOP -10
See
"Level Start / Level Stop"
Remote commands
on page 305
808
808
Publicité
