Publicité
Replacing Fuses
Instruction
Photo
1� Turn the Power Switch OFF on the rear of the Visual-ICE Cryoablation
System� Loosen the thumb screw on the cord retention clip�
2� Remove the power cord from the retention clip� Remove the two
screws that secure the retention clip and remove the retention clip from
the power inlet�
3� Insert a small screwdriver into the slot on the bottom of the fuse
holder to begin to snap the fuse holder out of the power inlet�
4� While holding your hand under the fuse holder, carefully slide the
fuse holder out of the power inlet�
NOTE: There are four fuses in the fuse holder�
5� Catch the fuse holder and fuses as the fuse holder is removed from
the power inlet� The two fuses that remain in the fuse holder are the
fuses that are part of the system circuit�
6� Replace the fuses in the fuse holder with the two loose fuses�
NOTE: Use only Boston Scientific specified fuses in the Visual-ICE
Cryoablation System�
73
Black (K) ∆E ≤5.0
Publicité
