Publicité
Table 13. Configure Settings Controls
Setting
MTS Needle
Locations
Cylinder Volume
Inactivity Timeout
Language
Maximize by Default Select a section of the Procedure Screen to be maximized by default at login�
Low Cylinder Alert
Link all channels
Passive thaw timer
count up
Active Flush
Display Sensor
Temperatures
FastThaw in Channel
Controls
Automatic Flush
Custom Fields
Upload Registration
Clear Hospital
Information
Time Zone
Pressure Units
Temperature Units
Control buttons at the top of the screen provide options to Manage Users and Manual Software Update�
Manage Users: Select your username and press the Change Password button to change your password� Administrative
users may add users, remove users, or change the password of any user�
Manual Software Update: Press the Manual Software Update button to install a software update via a USB flash
drive� This function is available only to administrative and service users�
Black (K) ∆E ≤5.0
Description
Customize the list of names to be provided for the MTS needles for each associated organ
map� Press Add Location to add a new name to the list� Press Remove Location to
delete a name from the list�
Select the gas cylinder volume and units of measure according to the standard in
the geographical region� The gas cylinder volume and units can only be changed by
administrative or service personnel�
Select the desired duration from 30 minutes to 180 minutes that the system can be inactive
before requiring you to re-enter your password� The default inactivity timeout is two hours�
Select the language in which the software is displayed�
Select the desired reminder interval (0 minutes to 15 minutes) for the Gas Indicator to
display an alert that the estimated remaining volume in the gas cylinder is low�
Check this box to automatically link all adjacent channels for simultaneous operation
(e�g�, 1 and 2, 3 and 4, 5 and 6, ...)
Check this box to automatically display elapsed time during passive thaw� The digital
timer reads Stopped and the time elapsed in passive thaw is indicated�
Unless disabled by removing the check from this box, an automated active 30 second
flush will follow a freeze cycle conducted at 50 % or higher intensity and lasting greater
than 3 minutes�
Check this box for a Channel Status display of the internal gas temperature at the needle
tip during freeze phase and the estimated temperature range of the needle shaft during
active thaw phases for i-Thaw Function and CX-type needles�
Check this box for display of the FastThaw Function icon in the Channel Controls when the
system is in i-Thaw Function mode and a FastThaw Function capable needle is connected�
Unless disabled by removing the check from this box, an automated gas line flushing will
occur after argon is connected and the gas lines pressurized�
Enter custom names to label the two custom fields available for entering information in
the Registration Screen �
Use the drop-down menu to enable or disable the option to upload registration data with
the procedure reports� By default, registration data is not uploaded� This function is only
available to administrative or service personnel�
Clear the hospital name, address, and physician name from the system history file�
The time zone can be changed by administrative or service personnel� The Visual-ICE
Cryoablation System automatically adjusts for Daylight Saving Time�
Select the units of pressure that the Gas Indicator displays�
Select the temperature units that the Temperature Sensors Section displays and graphs�
68
Publicité
