Honda BF40D Mode D'emploi page 820

17) Release the power tilt relay 2P connector from the harness
clip bracket A, and disconnect the power tilt relay 2P
connector [Power trim/tilt type only].
1
18) Release the alternator stator wire, main wire harness and
2
the power tilt relay ground cable [Power trim/tilt type only]
from the wire harness clip.
3
19) Remove the 6 x 12 mm flange bolt and remove the power
tilt relay ground cable [Power trim/tilt type only].
4
5
6
7
8
9
10
11
12
20) Disconnect the power tilt switch 3P connector, and release
13
the power tilt switch 3P connector from the harness clip
bracket A [Power trim/tilt type only].
14
21) Loosen the 6 x 12 mm flange bolt that secures the power tilt
15
switch stay [Power trim/tilt type only].
Tighten the 6 x 12 mm flange bolt again while pushing the
16 power tilt switch stay toward out (engine under case side)
[Power trim/tilt type only].
17
18
19
20
6-6
[2]
POWER TILT RELAY
2P CONNECTOR
[1]
WIRE HARNESS
CLIP
[6]
HARNESS
CLIP
BRACKET A
[5]
ALTERNATOR
STATOR WIRE
[1]
HARNESS CLIP
BRACKET A
[4]
ENGINE
UNDER
CASE
6 x 12
820
[3]
POWER TILT RELAY
GROUND CABLE
6 x 12
[4]
MAIN WIRE
HARNESS
[2]
POWER TILT SWITCH
3P CONNECTOR
[3]
POWER TILT
SWITCH STAY