Honda BF40D Mode D'emploi page 318

1
[1]
CLIP
2
Clamp the straight part of the air
vent tube with the clip opening
3 toward down and clamp the main
wire harness with
opening toward up.
4
5
6
[17]
7
FUEL TUBE CLAMP B
Install with the opening
8
toward out.
9
[16]
3.5 x 35 mm
10
FUEL TUBE
11
[15]
AIR VENT TUBE C
12
INSTALLATION: P. 2-84
13
[14]
PRESSURE REGULATOR
CONTROL TUBE
14
[4]
15
PAINT MARK
16
[13]
AIR VENT TUBE CLAMP
17
• Set the joint of the pressure
regulator control tube in the
18
smaller diameter side of the air
vent tube clamp and set the air
vent tube C in the larger
19
diameter side to clamp them.
• Install the air vent tube clamp
20
aligning the top end of the tube
clamp with the paint mark on the
air vent tube C.
[12]
TUBE CLIP B10
Install with the tab in
the direction shown.
2-85
[2]
MAIN WIRE
HARNESS
the clip
[11]
TUBE CLIP B12
Install with the
tab toward up.
[3] [5]
AIR VENT FUEL TUBE CLAMP D
STRAINER
Clamp the main wire harness
and pressure regulator control
tube aligning the top end of
the tube clamp with the paint
[4]
mark on the pressure regulator
PAINT MARK
control tube.
[10]
FUEL TUBE C
INSTALLATION: P. 2-84
318
[6]
AIR VENT TUBE A
[7]
TUBE CLIP B10
Install with the tab
toward the engine.
[8]
T-JOINT
[9]
AIR VENT
TUBE B