Honda BF40D Mode D'emploi page 762

Masquer les pouces Voir aussi pour BF40D:
Table des Matières

Publicité

5) Apply engine oil to the two new O-rings and install them on
the two anode metal caps respectively.
6) Install the anode metal caps on the intake manifold
assembly.
7) Connect the MAP sensor 3P connector and install the
harness band clip.
8) Install the fuel tube clamp B between the protection tubes
on the breather tube.
9) Connect the pressure regulator control tube to the intake
manifold assembly.
10) Install the pressure regulator control tube so that the mark
on the tube is at the right end of the 3.5 mm tube clip.
5-97
[2]
PRESSURE REGULATOR
CONTROL TUBE
[1]
PROTECTION
TUBES
[8]
FUEL TUBE
CLAMP B
[7]
3.5 mm TUBE CLIP
762
[1]
O-RING (2)
[2]
ANODE METAL
CAP (2)
[3]
MARK
[4]
BREATHER
TUBE
[5]
HARNESS
BAND CLIP
[6]
MAP SENSOR 3P
CONNECTOR

Hide quick links:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Bf50d

Table des Matières