Honda BF40D Mode D'emploi page 768

6) Remove the two 6 x 25 mm bolt/washers from the vapor
separator assembly.
7) Remove the two vapor separator grommets and the two
collars.
b. DISASSEMBLY
1) Remove the two 6 x 14 mm flange bolts and remove the
pressure regulator.
2) Remove the two O-rings and the backup ring from the
pressure regulator.
Replace the O-rings and the backup ring with the new ones.
3) Remove the three 5 mm screw washers and remove the
strainer cover, two O-rings, fuel strainer (high pressure
side) and the spring.
Replace the O-rings with the new ones.
4) Remove the service check bolt and remove the sealing
washer.
Replace the sealing washer with a new one.
5-100
[1]
VAPOR SEPARATOR
GROMMET (2)
[4]
COLLAR (2)
6 x 14 (2)
[4]
PRESSURE
REGULATOR
[3]
O-RING (SMALL)
[2]
SEALING
[1] WASHER
SERVICE
CHECK
BOLT
[8]
[7]
5 mm SCREW
STRAINER COVER
WASHER (3)
768
[2]
VAPOR SEPARATOR
ASSEMBLY
[3]
6 x 25 mm
BOLT/WASHER
[1]
BACKUP RING
[2]
O-RING (LARGE)
[4]
[3]
O-RING
O-RING
(LARGE)
(SMALL)
[5]
SPRING
[6]
FUEL STRAINER
(HIGH PRESSURE SIDE)