Honda BF40D Mode D'emploi page 780

e. REASSEMBLY
1) Apply engine oil to the new O-ring and install it on the
connector assembly.
2) Install the connector assembly aligning the projection on
the connector assembly with the recess in the vapor
separator cover.
3) Install the insulator on the vapor separator cover.
4) Set the plate and tighten the screw washer securely.
5) Install the ring on the pump cover.
6) Assemble the pump cover with the fuel pump (high
pressure side) aligning the projection on the fuel pump
with the hole in the pump cover.
5-106
[3]
CONNECTOR ASSEMBLY
[2]
PROJECTION
[1]
RECESS
[5]
VAPOR SEPARATOR COVER
[1]
INSULATOR
[4]
VAPOR SEPARATOR COVER
[1]
PROJECTION
[5]
PUMP COVER
780
[4]
O-RING
[2]
SCREW
WASHER
[3]
PLATE
[2]
FUEL PUMP
(HIGH PRESSURE SIDE)
[3]
RING
[4]
HOLE