Honda BF40D Mode D'emploi page 750

6) Disconnect the three injector 2P connectors.
7) Remove the 6 x 25 mm flange bolt. Release the harness
band clip and disconnect the IAC valve 2P connector.
8) Disconnect the pressure regulator control tube at the two
points. Release the harness band clip and disconnect the
breather tube and the MAP sensor 3P connector.
5-91
[1]
INJECTOR 2P
CONNECTOR (3)
[1]
HARNESS
BAND CLIP
[1]
BREATHER TUBE
[4]
MAP SENSOR 3P
CONNECTOR
750
6 x 25
[2]
IAC VALVE 2P
CONNECTOR
[2]
PRESSURE REGULATOR
CONTROL TUBE
[3]
HARNESS BAND CLIP