Honda BF40D Mode D'emploi page 370

Remote Control Cable [Throttle Side] Adjustment:
Check that the remote control cable [throttle side] is installed
on the throttle arm.
1
1) Remove the engine cover (P. 4-2).
2
2) Perform throttle rod adjustment (P. 3-17).
3
3) Set the throttle in the full open position.
4
5
6
7
8
9
10
11
12
4) When the throttle is in the full open position, check that the
13
throttle arm is in contact with the full open stopper A of the
throttle arm bracket, and check the clearance between the
14
throttle lever and the full open stopper B of the throttle
body. It must be 1 mm (0.04 in) or below.
15
5) When the throttle arm does not come in contact with the
16 full open stopper A or when the clearance is more than 1
mm (0.04 in), adjust as follows.
17
18
19
20
3-18
[1]
<TILLER HANDLE TYPE>
[2]
" " MARK
[4]
THROTTLE GRIP
[5]
<REMOTE CONTROL TYPE>
[7]
"F" (FORWARD)
[6]
REMOTE
CONTROL
LEVER
[9]
FULL OPEN
POSITION
[1]
[2]
THROTTLE
1 mm (0.04 in)
LEVER
or below
[8]
THROTTLE ARM
BRACKET
370
[3]
THROTTLE MARK
FULL OPEN POSITION
[8]
"N" (NEUTRAL)
[3]
THROTTLE
BODY
[4]
FULL OPEN
STOPPER B
[5]
THROTTLE
ARM
[6]
Contact.
[7]
FULL OPEN
STOPPER A