Honda BF40D Mode D'emploi page 314

[1]
FUEL TUBE CLAMP A
• Clamp the main wire harness
1
and breather tube B with the
opening of the fuel tube clamp A
2
toward the right-hand side.
• Install the fuel tube clamp A
aligning the top end of the tube
3
clamp with the paint mark on the
breather tube.
4
5
[20]
BREATHER TUBE B
6
[19]
HOSE JOINT
7
[18]
BREATHER TUBE A
8
[17]
9
FUEL HOSE
[16]
FUEL STRAINER
10
[LOW PRESSURE SIDE]
11
[15]
TUBE CLIP B12
12 Install with the tab in
the direction shown.
[14]
13
FUEL TUBE A
• Insert the fuel tube A aligning the " "
14
mark with the projection on the fuel
strainer [Low pressure side].
15
• Install so that the distance between the
engine under case and fuel tube A is 5
mm (0.2 in) or more as shown.
16
[14]-1
17
ENGINE
UNDER
CASE
18
5 mm
19
(0.2 in)
[13]
20
FUEL TUBE B
Insert the fuel tube B
aligning the " " mark with
the projection on the fuel
strainer [Low pressure
side].
[13]-1
PROJECTION
[13]-2
" " MARK
2-83
[21]
MAIN WIRE HARNESS
[14]-2
FUEL
TUBE A
[12]
TUBE CLAMP
D21.0
[11]
OIL TUBE
[10]
FUEL PUMP
[LOW PRESSURE
SIDE]
[4]
TUBE CLAMP 7.5-11.5
• Install the tube clamp with the opening toward
out. Clamp the drain tube on the small diameter
side of the tube clamp and clamp the fuel hose on
the larger diameter side.
• Install the tube clamp aligning the left end of the
tube clamp with the paint mark on the fuel hose.
[2]
PAINT MARK
[3]
FUEL LINE
[8]
TUBE CLIP B12
[9]
TUBE CLAMP Install with the tab
D18.8
toward up.
314
[5]
TUBE CLAMP
INSTALLATION:
P. 2-86
[2]
PAINT
MARK
[6]
DRAIN TUBE
[7]
FUEL TUBE C
INSTALLATION: P. 2-84