Honda BF40D Mode D'emploi page 818

14) Remove the DLC (data link connector) from the fuse box
bracket.
Remove the harness band clip of the main wire harness
1
from the electric part case.
2
3
4
5
6
7
8
9
10
11
12
15) Disconnect the trim angle sensor 3P connector, and release
13
the trim angle sensor wire from each clamp of the electric
part case [Power trim/tilt type only].
14
16) While pulling the main wire harness toward you, pull out
15
the trim angle sensor wire from the gap between the
electric part case and the main wire harness [Power trim/tilt
16 type only].
17
18
19
20
6-5
[2]
FUSE BOX BRACKET
[1]
DLC (DATA LINK
CONNECTOR)
[5]
MAIN WIRE HARNESS
[1]
TRIM ANGLE SENSOR 3P CONNECTOR
[5]
CLAMP
[4]
MAIN WIRE
HARNESS
818
[3]
ELECTRIC PART CASE
[4]
HARNESS BAND CLIP
[2]
ELECTRIC PART CASE
[3]
TRIM ANGLE
SENSOR WIRE