Honda BF40D Mode D'emploi page 758

5) Align the projection on the throttle body with the recess in
the silencer grommet as shown.
6) Set the air flow band so its threaded part is between the
projections on the silencer as shown.
7) Tighten the air flow band to the dimension shown.
8) Install the throttle rod on the throttle body.
9) Connect the IAT sensor 2P connector and the TP sensor 3P
connector as shown.
10) Insert the breather tube up to the marked point into the
silencer.
11) Install the engine cover (P. 4-2).
5-95
[1]
PROJECTION
[3]
RECESS
[2]
THROTTLE ROD
[1]
TP SENSOR 3P
CONNECTOR
[3]
[4]
IAT SENSOR 2P CONNECTOR
MARK
758
[1]
PROJECTION
10 mm (0.4 in)
[2]
THREADED
PART
[1]
PROJECTION
[1]
THROTTLE
BODY
[2]
BREATHER TUBE