Atlas Copco XAS96 DdG Manuel D'instructions page 37

8. INSTALLATION RECOMMENDATIONS
FOR FRAME SUPPORT
Instrument panel this end
Fig. 8.1 Installing the compressor on the truck floor
ø15
5 0
ø15
5 0
Fig. 8.2 Parts required
1
0
Truck bed or floor
ø15
5 0
M12
?
For support mounted portable compressors we
recommend the use of Atlas Copco option ÓSupport
mountedÓ. If for technical reasons, this option can not be
used, the following recommendations should be followed
ensuring a safe installation:
Remove towbar, shaft, bumper and mudguards (if installed).
Ð Determine the position of the compressor on the bed or floor of
the truck.
When doing so, take into account:
Ð weight of the compressor
Ð dimensions of the compressor
Ð position of the instrument panel
Ð position of the engine exhaust outlet
Ð position of the compressed air outlet valves
Ð opening and closing of the compressor doors.
Drill holes with a diameter of 15 mm in the bed or floor of the truck,
according the pattern in Fig. 8.1 (General tolerance: ± 1 mm).
Prepare the required supports according Fig. 8.2.
Use only materials and parts of sufficient strength and stability.
2 blocks of 50 mm x 50 mm x 425 mm
(2 holes with a diameter of 15 mm)
2 blocks of 50 mm x 50 mm x 325 mm
(2 holes with a diameter of 15 mm)
1 block of 50 mm x 50 mm x 260 mm
(2 holes with a diameter of 15 mm)
10 washers for M12
10 bolts of M12 (strength at least 8.8), ? mm long
I M
NSTRUCTION ANUAL
37