General Torques - YAMAHA Marine 100A Manuel D'entretien

SPEC
Nut (A) Bolt (B)
8 mm M5
10 mm M6
12 mm M8
14 mm M10
17 mm M12
TIGHTENING TORQUES
General torque
specifications
Nm m•kgf ft•lb
5 0.5 3.6
8 0.8 5.8
18 1.8 13
36 3.6 25
43 4.3 31
2140

GENERAL TORQUES

This chart specifies tightening torques for
standard fasteners with a standard ISO
thread pitch. Tightening torque specifica-
tions for special components or assemblies
are provided in applicable sections of this
manual. To avoid warpage, tighten multi-
fastener assemblies in a crisscross fashion
and progressive stages until the specified
tightening torque is reached. Unless other-
wise specified, tightening torque specifica-
tions require
Components should be at room tempera-
ture.
2-19
clean, dry threads.
E