Table des Matières
Publicité
LOWR
SHIMMING (COUNTER ROTATION MODELS)
(FOR USA AND CANADA)
6525
6527
6530
SELECTING THE REVERSE GEAR
SHIMS
NOTE:
Find the shim thickness (T1) by selecting
shims until the specified value (M0) is
obtained with the special tool.
1. Measure:
• Specified measurement (M)
Out of specified value (M0) → Adjust.
Specified value (M0) =
25.30 + F/100 mm
Measuring steps
(1) Calculate the specified value (M0).
NOTE:
• "F" is the deviation of the lower case
dimension from standard. It is stamped
on the trim tab mounting surface of the
lower case in 0.01-mm units. If the "F"
mark is missing or unreadable, assume an
"F" value of "0", and check the backlash
when the unit is assembled.
• If the "F" mark is negative (–), then sub-
tract the "F" value from the measure-
ment.
Example:
If "F" is "+5", then
M0 = 25.30 + (+5)/100 mm
= 25.30 + 0.05 mm
= 25.35 mm
If "F" is "–3", then
M0 = 25.30 + (–3)/100 mm
= 25.30 – 0.03 mm
= 25.27 mm
6-77
E
Publicité
Table des Matières
