Table des Matières
Publicité
INSP
ADJ
CONTROL SYSTEM
3080
3081
3082
Inspecting steps
(1) Turn the magneto control lever so that
the full retard adjusting screw contacts
the crankcase.
(2) Check that the mark a on the throttle
cam aligns with the center of the throt-
tle roller 1.
2. Adjust:
• Pickup timing
Adjustment steps
(1) Adjust the throttle cam control link 1
to the specified length a.
Throttle cam control link length
53.0 mm (2.09 in)
(2) Turn the magneto control lever 2 so
that the full retard adjusting screw 3
contacts the crankcase 4.
(3) Loosen the throttle roller adjusting
screw 5.
(4) Align the mark a on the throttle
cam 6 with the center of the throttle
roller 7.
(5) Tighten the throttle roller adjusting
screw 5.
3-11
E
Publicité
Table des Matières
