Table des Matières
Publicité
INSP
ADJ
b
a
CONTROL SYSTEM
3122
3126
3127
2. Adjust:
• Remote control throttle cable length
Adjustment steps
(1) Loosen the locknut 1.
(2) Remove the clip 2.
(3) Disconnect the cable joint at the mag-
neto control lever 3.
(4) Close the throttle grip fully.
(5) Turn the magneto control lever so that
the full retard adjusting screw 4 con-
tacts the crankcase.
(6) Adjust the position of the throttle cable
joint until its hole aligns with the set
pin.
(7) Install the clip and tighten the locknut.
CAUTION:
The remote control cable joint must be
screwed in more than 8 mm (0.31 in).
ADJUSTING THE START-IN-GEAR
PROTECTION (E115AMH, E115AWH)
1. Inspect:
• Start-in-gear protection operation
Incorrect → Adjust.
2. Adjust:
• Start-in-gear protection wire adjuster
position
Adjustment steps
(1) Set the shift lever in the neutral posi-
tion.
(2) Loosen the bolt 1.
(3) Adjust the start-in-gear protection wire
adjuster 2 so that the point a on the
wire connector aligns with the mark b
on the flywheel cover.
(4) Tighten the bolt.
3-13
E
3
Publicité
Table des Matières
