Sync Mode - Steinberg HALION4 Mode D'emploi

LFO Waveform and Shape
Waveform selects the basic type of waveform. Shape changes the characteristic of
the waveform.
Option
Sine
Triangle
Saw
Pulse
Ramp
Log
S & H 1
S & H 2

Sync Mode

You can sync the LFO to the tempo of the host application. The behavior of the
Frequency parameter changes with the selected option:
Option
Off
Tempo + Retrig
Tempo + Beat
Retrigger Mode
This defines whether the LFO is restarted when a note is triggered. The waveform
restarts at the position you specify with the Phase parameter.
The polyphonic LFOs can switch between Retrigger On and Off: When it is off, the
LFO runs freely, when set to On, the LFO starts with each triggered note.
Frequency
This controls the frequency of the modulation, that is, the speed of the LFO. When
Sync is activated, the frequency is set in fractions of beats.
Description
This produces smooth modulation, suitable for vibrato or tremolo.
Shape adds additional harmonics to the waveform.
This is similar to Sine. Shape continuously changes the triangle
waveform to a trapezoid.
This produces a ramp cycle. Shape continuously changes the
waveform from ramp down to triangle to ramp up.
This produces stepped modulation, where the modulation switches
abruptly between two values. Shape continuously changes the ratio
between the high and low state of the waveform. With Shape set to
50 %, a square wave is produced.
This is similar to the Saw waveform. Shape increasingly puts silence
before the sawtooth ramp up begins.
Shape continuously changes the logarithmic curvature from
negative to positive.
This produces randomly stepped modulation, where each step is
different. Shape puts ramps between the steps and changes the
S&H into a smooth random signal when fully turned right.
This is similar to S & H 1. The steps alternate between random high
and low values. Shape puts ramps between the steps and changes
the S & H into a smooth random signal when fully turned right.
Description
Select this to adjust the speed of the modulation in Hertz.
Select this to adjust the speed of the modulation in fractions of
beats. You can also set dotted and triplet note values. The restart
behavior of the LFO depends on the Retrigger Mode.
Select this to adjust the speed of the modulation in fractions of
beats. You can also set dotted and triplet note values. The LFO
restarts with the transport of the host and lines up to the beats of
the song. The Retrigger setting is not taken into account.
124
Editing Zones in the Sound Editor
The LFO Section