Steinberg HALION4 Mode D'emploi page 114

Filter shape
HP18
HP12
HP6
BR12
BR24
BR12+LP6
BR12+LP12
BP12+BR12
HP6+BR12
HP12+BR12
AP
AP+LP6
HP6+AP
Cutoff
Here, you can adjust the cutoff frequency of the filter. The effect depends on the
selected filter type.
X/Y Control
The X/Y control allows you to adjust two parameters simultaneously. This is especially
useful with the morphing filters, where the X/Y control adjusts the mix between the
filter shapes. For the other filter modes, the X/Y control adjusts cutoff and resonance.
Depending on the selected filter type, the X/Y control adjusts different parameters:
Filter
Single, Dual Serial
& Dual Parallel
Morph 2 and 4
Morph XY
Description
High-pass filter with 18 dB/oct. Frequencies below the cutoff are
attenuated.
High-pass filter with 12 dB/oct. Frequencies below the cutoff are
attenuated.
High-pass filter with 6 dB/oct. Frequencies below the cutoff are
attenuated.
Band-reject filter with 12 dB/oct. Frequencies around the cutoff are
attenuated.
Band-reject filter with 24 dB/oct. Frequencies around the cutoff are
attenuated.
Band-reject filter with 12 dB/oct plus low-pass filter with 6 dB/oct.
Frequencies around and above the cutoff are attenuated.
Band-reject filter with 12 dB/oct plus low-pass filter with 12 dB/oct.
Frequencies around and above the cutoff are attenuated.
Band-pass filter with 12 dB/oct plus band-reject filter with
12 dB/oct. Frequencies below, above and around the cutoff are
attenuated.
High-pass filter with 6 dB/oct plus band-reject filter with 12 dB/oct.
Frequencies below and around the cutoff are attenuated.
High-pass filter with 12 dB/oct plus band-reject filter with
12 dB/oct. Frequencies below and around the cutoff are attenuated.
All-pass filter with 18 dB/oct. Frequencies around the cutoff are
attenuated.
All-pass filter with 18 dB/oct plus low-pass filter with 6 dB/oct.
Frequencies around and above the cutoff are attenuated.
High-pass filter with 6 dB/oct plus all-pass filter with 18 dB/oct.
Frequencies around the cutoff are attenuated.
Description
The X/Y control adjusts the cutoff frequency on the horizontal and
resonance on the vertical axis.
The X/Y control adjusts the morphing between the filter shapes on
the vertical (Morph Y) axis. The horizontal axis adjusts the cutoff
frequency.
The X/Y control adjusts the morphing between the filter shapes AD
and BC on the horizontal (Morph X), and AB and DC on the vertical
axis (Morph Y).
114
Editing Zones in the Sound Editor
The Filter Section