Steinberg HALION4 Mode D'emploi page 174

Modulation Effects
Depth
This sets the intensity of the pitch modulation.
Phase
This widens the sound image of the effect from mono to stereo.
Shape
This adjusts the characteristic of the modulation. At a setting of 0 % the pitch changes
continuously, producing a steady modulation. At a setting of 100 % the pitch does not
change all the time, producing a less steady modulation.
Mix
This controls the mix between the dry and the wet signal.
Flanger
The Flanger effect thickens and broadens the sound by means of pitch modulation.
The Feedback parameter allows you to add resonances allowing for jet-like sweeps of
the sound.
Rate
Use this to specify the frequency of the pitch modulation in Hertz (Hz).
Sync
Activate this to set the Rate value in fractions of beats.
Depth
This sets the intensity of the pitch modulation.
Phase
This widens the sound image of the effect from mono to stereo. The Phase parameter
also changes the characteristic of the Cross Feedback parameter.
Shape
This adjusts the characteristic of the modulation. You hear this best with the
Feedback parameter turned on. At a setting of 0 % the sound sweeps linearly up and
down. At a setting of 100 % the sound sweeps exponentially up and down.
Mix
This controls the mix between the dry and the wet signal.
Feedback
This adds resonances to the effect.
Cross FB
This mixes the feedback of the left channel with the right channel, and vice versa. This
parameter only takes effect if the Feedback parameter is set to a value above 0 %. The
setting of the Phase parameter influences the Cross FB parameter.
Tone
This adjusts the tone color of the feedback. If you set this parameter to lower values
the feedback is less bright.
174
Effects Reference