Cc Mapper - Steinberg HALION4 Mode D'emploi

CC Mapper

The CC Mapper allows you to map MIDI controllers to other MIDI controllers before
they are passed on to the following layers and zones. You can also use it to transform
incoming values using curves.
MIDI controllers, Aftertouch and Pitch Bend can be mapped freely to all MIDI
controllers, Aftertouch, Pitch Bend, and the eight global controllers Contr. A to
Contr. H. Velocity and the global controllers themselves can only be mapped to
Contr. A to Contr. H.
To map a MIDI Controller to another MIDI Controller (or Aftertouch or Pitchbend),
click in the Source column for the MIDI controller and select a new item from the list.
Velocity can only be used as Source for the global controllers Contr. A to Contr. H.
Contr. A to Contr. H allow you to change the MIDI controller assignment via a single
setting in the CC Mapper instead of changing the modulation matrix assignments of
the single zones separately, for example. This can be achieved by assigning them in
the modulation matrix and mapping a MIDI controller or velocity to them using the CC
Mapper.
Source
Here you can specify the source controller that is to be remapped. By default, no
remapping is processed and all controllers are passed through.
Controller
This column lists the available destination controllers.
Bypass
Click the bypass button for a controller to deactivate the remapping for it.
Min
This defines the minimum value to be sent.
Max
This defines the maximum value to be sent.
Using the Curve and Range Editor
You can set up a curve and range for each remapped source. The curve and range
editor displays the settings of the selected source controller, marked by an orange
frame. To select a different source, click the button to the left of it.
213
MIDI Modules Reference
CC Mapper