Steinberg HALION4 Mode D'emploi page 153

Setting Up Loop Crossfades
To create smooth loops, you can use crossfades. To set up a loop crossfade, proceed
as follows:
1. Activate the "e" button on the Sample editor toolbar to enter edit mode.
Crossfade handles are displayed on the waveform.
2. Click the "Sustain/Release Loop" icon (S/R) on the toolbar to select whether you
want to edit the sustain or the release loop.
3. Drag the crossfade handles with the mouse, or specify the crossfade range
numerically in the parameter section.
To see the effect of the crossfade, you can activate the "Show Resulting Loop
Crossfade" option on the toolbar. When this is activated, the resulting waveform is
displayed in red.
Adjusting the Crossfade Curve
You can specify a linear curve, an equal power curve, or anything in between.
• Drag the middle of the fade curve up or down, or adjust the Curve value in the
parameters section.
Adjusting the Tuning
Using the Tuning option on the Loop tab in the parameters section, you can set the
tuning of the loop. This is useful to adjust the frequency of the loop.
Using Loopsets A and B
In the Loopset section on the Loop tab in the parameters section, you can set up two
different sets of loops for the same sample. This is useful to compare different
versions of the same loop, for example.
153
Editing Samples in the Sample Editor
Creating Loops