Steinberg HALION4 Mode D'emploi page 56

Adjusting the Curvature
You can adjust the curvature of each assignment separately.
Proceed as follows:
1. On the left of the Quick Controls Assignment section, select the quick control you
want to edit.
2. On the right, specify the curvature in the value field between the minimum and
maximum value field.
Positive values change the curvature towards logarithmic and negative values
towards exponential behavior.
You can also edit the curvature graphically in the display on the right by dragging it up
and down.
Setting the Behavior of Quick Control Assignments
A quick control behaves either as continuous control or as a switch. In addition, it
remote-controls a parameter either in relative or absolute mode. Relative mode changes
the values of the assigned parameters without loosing their relative settings. Absolute
mode changes the assigned parameters by overwriting them with the current quick
control value. You can specify a mode for each assignment. You can set the behavior in
the context menu for the control itself or via the pop-up menu in the Quick Control
Assignments section.
The following options are available:
Option
Relative
Absolute
Switch Relative
Switch Absolute
Receiving Quick Controls
In the upper right corner of the Quick Control Assignments section the Receive Quick
Controls button is located. Use this button to determine whether zones inside a layer
respond to quick controls. This includes any single and multi assignment to zones.
Quick control assignments belonging to the layer itself are not affected.
This is useful if you assigned quick controls to the whole program and you want to
exclude parts of it, such as the layer containing the instrument noises.
Proceed as follows:
1. In the Program Tree, select the program or layer that you want to respond to the
quick controls.
2. In the Quick Control Assignments section, click the "Receive Quick Controls"
button (the antenna icon).
When the Antenna button is activated, zones inside a layer respond to quick
controls from outside.
Bypassing Quick Controls
To hear a sound without quick control assignments, bypass them temporarily by
clicking the corresponding Mute button in the Quick Control Assignments section.
Description
Remote-controls the parameter values continuously.
Parameter changes can still be heard.
Remote-controls the parameter values continuously.
Parameter changes are overwritten.
Switches between the minimum and maximum value.
Parameter changes can still be heard.
Switches between the minimum and maximum value.
Parameter changes are overwritten.
56
Global Functions and Settings
Quick Controls