Steinberg HALION4 Mode D'emploi page 106

The waveform parameters for OSC1, OSC2, and OSC3 can be assigned as
modulation destinations in the modulation matrix.
OSC 1/2/3 Waveform
The waveform parameter allows you to modify the sound of the oscillator algorithm. Its
effect depends on the selected oscillator type.
OSC 1/2/3 Octave (Oct)
Here, you can adjust the pitch in octave steps.
OSC 1/2/3 Coarse (Crs)
Here, you can adjust the pitch in semitone steps.
OSC 1/2/3 Fine
This parameter allows you to fine-tune the pitch in steps of cents (hundredths of a
semitone).
OSC 1/2/3 Level
This adjusts the output level of the oscillator.
The waveform, pitch and level of oscillator 1, 2, and 3 can be modulated separately in
the modulation matrix.
Sub Oscillator (SUB)
The pitch of the sub oscillator is always one octave below the overall pitch of the synth
zone. If you modulate the pitch of the synth zone, the pitch of the sub oscillator
follows.
• To activate and deactivate the sub oscillator, click its On/Off button.
The following parameters are available:
Parameter
Sub Oscillator
Type
Sub Oscillator
Level
Ring Modulation (RING)
Ring modulation produces sums and differences between the frequencies of two
signals.
• To activate ring modulation, click the On/Off button.
The following parameters are available:
Parameter
Ring Modulation
Source 1/2
Ring Modulation
Level
Description
Here, you can select the wave shape of the sub oscillator. You can
choose between Sine, Triangle, Saw, Square, Pulse Wide, and
Pulse Narrow.
This adjusts the output level of the sub oscillator.
Description
This allows you to select the sources to be ring modulated. You
can select OSC1 or Sub as Source 1, and OSC2 or OSC3 as
Source 2.
This adjusts the output level of the ring modulation.
106
Editing Zones in the Sound Editor
The Oscillator Section