Ai-Knob Support - Steinberg HALION4 Mode D'emploi

Assigning Quick Controls in the Modulation Matrix
In addition to assigning the quick controls directly to parameter controls, you can also
assign them as source or modifier in the modulation matrix. This way, you can combine
the quick control with other modulation sources.
Proceed as follows:
1. In the Program Tree, select the zones you want to edit. Make sure that the zones
are part of the program or layer with the quick controls you want to use.
2. In the Sound editor, open the Modulation Matrix section.
3. On the pop-up menu in the Source/Modifier column, open the Assign Quick
Control submenu, and select the quick control.
The submenu lists only the quick controls that belong to the same layer or that are
on a higher hierarchy level.

AI-Knob Support

HALion can be controlled with the ai-knob of Steinberg's CC121, CI 2, and CI2+
controller units.
• To change a parameter value, move the mouse pointer over the control you want to
change and turn the ai-knob to set the value.
Certain parameters cannot be controlled by the ai-knob due to internal differences in
parameter resolution. For example, sample marker positions cannot be changed with
the ai-knob because their ranges vary too much.
57
Global Functions and Settings
AI-Knob Support