Automation And Factory Midi Controller Assignments; Cc 121 Support - Steinberg HALION4 Mode D'emploi

Restoring the Factory MIDI Controller Assignment
To restore the factory MIDI controller assignments, open the Options editor, and in the
MIDI controller section, click "Reset to Factory".

Automation and Factory MIDI Controller Assignments

The following parameters show the controller numbers and names of the default
factory MIDI controller assignment.
Parameter
Volume
Pan
Mute
Solo
Send FX 1*
Send FX 2*
Send FX 3*
Send FX 4*
Program QC 1
Program QC 2
Program QC 3
Program QC 4
Program QC 5
Program QC 6
Program QC 7
Program QC 8
*Only available if the corresponding AUX Send effect is loaded.
The assigned MIDI controller numbers are the same for all 64 slots. However, the MIDI
controllers listen only to the MIDI channels of the corresponding slot.
You can use MIDI controllers inside the modulation matrix of a synth or sample layer,
for example, to control the cutoff.

CC 121 Support

HALion can be controlled with the AI knob of Steinberg's CC121 MIDI controller unit.
To change a parameter value, proceed as follows:
1. Move the mouse pointer over the control you want to change.
2. Turn the AI knob to set the value.
The AI knob only works on parameters that are automatable. This means, for example,
that you cannot use the AI knob to change the parameters of the Options editor.
Automation and Factory MIDI Controller Assignments
Controller number
#07
#10
-
-
#91
#92
#93
#94
#74
#71
#73
#72
#75
#76
#77
#78
158
MIDI Editing and Controllers
Name
Volume
Pan
-
-
Effect 1 Depth
Effect 2 Depth
Effect 3 Depth
Effect 4 Depth
Brightness
Harmonic Content
Attack Time
Release Time
Sound Controller #6
Sound Controller #7
Sound Controller #8
Sound Controller #9