Stereo Delay; Tape Delay - Steinberg HALION4 Mode D'emploi

Early Reflections
A short, dense reverb for simulating small acoustic spaces and to thicken or blur
sounds.
Parameter
Time
Low EQ
High EQ
Mix
Delay
A simple mono-in/stereo out delay.
Parameter
Delay
Sync On/Off
Feedback
Balance
HF Damp

Stereo Delay

A stereo-in/stereo out delay.
Parameter
Delay
Feedback
Sync On/Off
Balance
HF Damp
Long Delay
The Long Delay provides the same parameters set as the Delay, except delays up to
four seconds can be set.

Tape Delay

Simulation of a vintage 4-head analog tape delay.
Parameter
Delay
Sync On/Off
Description
Length of reverb tail. It also allows you to change the sound
from dense early reflections to a trashy, grainy 80's-type reverb.
Low-cut EQ.
High-cut EQ.
Wet/dry mix.
Description
Delay time. If the Sync parameter is set to On, the delay time is
set using various note values.
By activating Sync, delays are synced to the tempo set in your
host application.
Feedback controls the number of delay repeats.
Ratio of left delay time to right delay time.
High-cut filter to soften delay repeats.
Description
Delay time. If the Sync parameter is set to On, the delay time is
set using various note values.
Feedback controls the number of delay repeats. For minimum
feedback set the slider to the mid position. By moving the slider
to the left or right "cross delay" is applied, where left output
feeds back into right input or vice versa.
By activating Sync, delay repeats are synced to the tempo set
in your host application.
Ratio of left delay time to right delay time.
High-cut filter to soften delay repeats.
Description
Delay time. If the Sync parameter is set to On, the delay time is
set using various note values.
By activating Sync, the delay repeats are synced to the tempo
set in your host application.
185
Effects Reference
HALion 3 Legacy Effects