Steinberg HALION4 Mode D'emploi page 78

The Slice Player Controls
Most of the Slice Player controls are the same as for the FlexPhraser MIDI module.
These are described in detail in the section
controls that differ for the Slice Player are described in the following sections.
Slice Player Presets
At the top right of the Program Tree, you can load and save presets for the Slice
Player. These presets are saved in a global folder and can be accessed from any
project you are working in.
Restart Mode
Depending on the selected Restart mode and your playing, you can restart playback
from the beginning of the loop.
You can select one of the following options:
Option
Off
First Note
Each Note
Sync to Host
Start
This parameter allows you to shift the start of the loop in steps of 1/4 notes. The
length of the loop is shortened accordingly.
Length
This parameter allows you to shorten the length of the loop in steps of 1/4 notes.
The control range of the parameters Start and Length varies with the original length of
the loop.
Quantize
This parameter allows you to set up a quantization grid, in fractions of beats. You can
also specify dotted and triplet values. This way, you can force the timing of the slices
to play back only at the selected note value.
Amount
This parameter defines how much of the quantization grid is applied. A value of 100 %
means the slices play back only at the Quantize note value you specified. Smaller
values move the notes only partially towards the next Quantize note value. With a
value of 0 % no quantization is applied at all.
Key Follow
Here you can adjust the pitch modulation by note number. Set this parameter to
positive values to raise the pitch with notes above the center key. Use negative values
to lower the pitch with notes above the center key. At +100 %, the pitch follows the
played note exactly.
The Key Follow parameter is limited to the keys that trigger the entire loop. It does not
affect the keys that play the single slices.
Description
The loop runs continuously and does not restart upon note changes.
The loop restarts when a note is triggered and no other notes are
already held.
The loop restarts each time a note is triggered.
Select this to align the loop with the beats and measures of your
host application. The loop aligns to the beats and measures each
time you start the transport.
78
Importing and Exporting Samples
Importing Sliced Loops
"The FlexPhraser" on page 192. The