The Filter Section; Filter Mode - Steinberg HALION4 Mode D'emploi

The Filter Section

The Filter section for synth and sample zones allows you to adjust the tone color of the
sound.
Filter Type
By selecting the filter type, you specify the basic sound character of the filter. Note
that filters without distortion use less processing power.
The following filter types are available:
Filter type
Off
Classic
Tube Drive
Hard Clip
Bit Red
(Bit Reduction)
Rate Red
Rate Red KF
Waldorf
HALion 3

Filter Mode

The buttons on the left of the Filter section determine the overall filter structure. The
filter types provide the following options:
Filter mode
Single Filter
Dual Filter Se rial This mode uses two separate filters connected in series. You can
Dual Filter
Parallel
Description
The filter section is switched off.
This filter type offers 24 filter shapes with resonance.
This filter type offers a lot of character by adding warm, tube-like
distortion. You can set the amount of tube drive with the Distortion
parameter.
This filter type adds bright, transistor-like distortion. You can set the
amount of hard clipping with the Distortion parameter.
This filter type adds digital distortion by means of quantization noise.
You can adjust the bit reduction with the Distortion parameter.
This filter type adds digital distortion by means of aliasing. You can
adjust the rate reduction with the Distortion parameter.
As above, but with Key Follow: The rate reduction follows the
keyboard, so the higher you play, the higher the sample rate.
This filter type offers 14 filter shapes, including two comb filters.
This filter type offers the 5 legacy filter shapes from HALion 3.
Description
This mode uses one filter with one selectable filter shape.
select the filter shapes for each filter independently. The parameters
Cutoff and Resonance control both filters simultaneously. However,
you can offset the cutoff and resonance of the second filter with the
parameters CF Offset and Res Offset.
This mode uses two separate filters connected in parallel. You can
select the filter shapes for each filter independently. The parameters
Cutoff and Resonance control both filters simultaneously. However,
you can offset the cutoff and resonance of the second filter with the
parameters CF Offset and Res Offset.
112
Editing Zones in the Sound Editor
The Filter Section