Loading And Managing Programs; Introduction; The Columns Of The Program Table - Steinberg HALION4 Mode D'emploi

Introduction

HALion allows you to load a virtually unlimited number of programs per instance. All
loaded programs, that means, programs that can be used in the current project, are
shown in the Program Table. You can load these programs into any of the 64 slots in
the Slot Rack.
The first 128 entries of the Program Table correspond to the 128 MIDI program
change numbers. You can load these programs into a slot by sending MIDI program
change messages on the slot's MIDI channel.
You can set the focus on any of the programs, for example to verify settings or to copy
zones from there, without having it assigned to any slot. In that case you cannot play
and hear the program.

The Columns of the Program Table

The Program Table contains the following columns:
Column
Program Number
Program Name
Used
Preload
File Size
Configuring Columns
Inserting Columns
• Right-click the column header at the position where you want to insert the new
column, and select the parameter or column that you want to insert.
Removing Columns
• Right-click the header of the column you want to remove, and select "Remove...".
Reordering Columns
• Drag and drop the header of the column left or right to the new position.
Changing the Width of a Column
• Drag the right border of the column header left or right to change its width.
All modifications are stored with the project.

Loading and Managing Programs

Description
Displays the program number, which corresponds to the
MIDI program change number.
Shows the program name. The name can be edited in place.
Displays the number of slots in which the program is loaded.
Shows if a program is preloaded, even if it is not being used
in a slot.
Displays the size of the program with all samples as it is
stored on the hard disk.
30