Steinberg HALION4 Mode D'emploi page 104

Multi-Oscillator Mode
For the three main synth oscillators, you can activate the Multi-Oscillator mode. This
mode allows you to create a richer sound by producing up to 8 oscillators
simultaneously. The effect is similar to the Unison mode for the zone, but it requires
less performance.
• To activate Multi-Oscillator mode, activate the MOsc button.
When Multi-Oscillator mode is activated, you can click the edit button to show the
corresponding parameters.
The following parameters are available:
Parameter
Number of
Oscillators
Oscillator Detune Detunes the oscillators.
Stereo Spread
Editing the Parameters in the Modulation Matrix
When Multi-Oscillator Mode is active for an oscillator, you can modulate the
corresponding parameters in the modulation matrix.
1. In the modulation matrix, open the Modulation Destinations pop-up menu.
2. On the Synth submenu, select the destination that you want to edit.
3. Set up the Modulation Source and Depth parameters.
Description
Determines the number of oscillators that play back simultaneously.
You can also set fractions of numbers. For example, with a setting of
2.5, you hear two oscillators at full level and a third one at half level.
Narrows or widens the stereo panorama. With a setting of 0 %, you
create a mono signal, and with 100 %, you create a stereo signal.
104
Editing Zones in the Sound Editor
The Oscillator Section