Ricoh MPC 2800 AT-C2 Mode D'emploi page 721

Side-to-Side Registration
002
(2nd side)
003 Leading Edge Registration
Adjusts the amount of paper buckle to correct original skew for the front and rear sides.
005 Buckle: Duplex Front
006 Buckle: Duplex Rear
Adjusts the erase margin at the original trailing edge.
007 Rear Edge Erase
[ADF Input Check]
6007
Displays the signals received from the sensors and switches of the ARDF. Only Bit 0 is used
for ADF input check (* "Iutput Check Table" in this section").
[ADF Output Check]
Activates the electrical components for functional check.
6008
It is not possible to activate more than one component at the same time (* "Output Check
Table" in this section")
[ADF Free Run]
6009
Performs a DF free run in simplex, duplex mode or stamp mode.
001 Free Run Simplex Motion
002 Free Run Duplex Motion
003 Free Run Stamp Motion
[Stamp Position Adj.] Fax Stamp Position Adjustment
6010
Adjusts the horizontal position of the stamp on the scanned originals.
6010 1 Stamp Position Adj.
[Original Size Detection Priority] Original Size Detection Priority
6016
[-5.0 to 5.0 / 0 / 0.1 mm/step ]
[-3.0 to 3.0 / 0 / 0.1 mm/step ]
*ENG
[-2.5 to 2.5 / 0 / 0.1 mm/step ]
*ENG [-10 to 10 / 0 / 0.1 mm/step ]
-
- -
-
*ENG [-5.0 to 5.0 / 0 / 1 mm/step]
System Service Mode
8
353