Ricoh MPC 2800 AT-C2 Mode D'emploi page 601

Displays the number of the ITB encodre error. SC443 is displayed if this counter counts to
"3".
[SecondaryFB: Threshold] Paper Transfer Roller Feed-back: Threshold Adjustment
2930
Adjusts the threshold between high resistance (division 1) and low resistance (division 2) at
the paper transfer roller. This SP affects SP2931 to SP2939.
001 Voltage
2960 [Process Interval]
Additional Time
001
Adjusts the additional time for ending the machine's process.
2970 [Cleaning After JOB]
001 No Refresh
002 Refresh
2971 [T1 Non Image Area ON Timing] DFU
001
Adjusts the timing for the non-image area bias of the image transfer roller.
SP3-XXX (Process)
3011 [Process Cont. Manual Execution]
001 Normal
002 Density Adjustment
*ENG [0 to 7000 / 6000 / 10 –V/step]
*ENG [0 to 10 / 0 / 1 sec/step]
[0 or 1 / 0 / 1 /step]
*ENG
0: No cleaning, 1: Cleaning
[0 or 1 / 1 / 1 /step]
*ENG
0: No cleaning, 1: Cleaning
*ENG [–270 to 180 / 0 / 10 msec/step]
Executes the normal process control manually
(potential control).
-
Check the result with SP3-325-001 and
3-012-001 after executing this SP.
- Executes the toner density adjustment manually.
System Service Mode
8
233