Ricoh MPC 2800 AT-C2 Mode D'emploi page 467

No. Type
HDD mail transfer error
An error is detected in the HDD at machine initialization.
CTL
• Defective HDD
873
B
• Power failure during an access to the HDD
1. Initialize the HDD partition (SP5-832-008).
2. Replace the HDD.
No. Type
Delete All error 1: HDD
An error is detected while all of the HDD or NVRAM are formatted physically by
the Data Overwrite Security Unit (D377).
CTL
874
• Data Overwrite Security Unit (SD card) not installed
D
• Defective HDD
1. Install the Data Overwrite Security Unit (D377).
2. Replace the HDD.
No. Type
Delete All error 2: Data area
An error is detected while all of the HDD or NVRAM are formatted logically by the
CTL
Data Overwrite Security Unit (D377).
875
D
• The logical format for the HDD fails.
Turn the main switch off/on and try the operation again
No. Type
Log Data Error
CTL
876
An error was detected in the handling of the log data at power on or during machine
D
operation. This can be caused by switching the machine off while it is operating.
-001 Log Data Error 1
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC Tables
3
99