Ricoh MPC 2800 AT-C2 Mode D'emploi page 667

5148 Size Detection Off
001 Enables or disables the automatic paper size detection for the by-pass tray.
5150 [By-Pass Length Setting]
Determines whether the transfer sheet from the by-pass tray is used or not.
001
Normally the paper length for sub scanning paper from the by-pass tray is limited to 600
mm, but this can be extended with this SP to 1260 mm.
5162 [App. Switch Method]
001 This program specifies the switch that selects an application program.
[Fax Printing Mode at Optional]
5167
Enables or disables the automatic print out without an accounting device. This SP is used
when the receiving fax is accounted by an external accounting device.
Fax Printing Mode at Optional
001
Counter Off
[CE Login]
5169
If you will change the printer bit switches, you must 'log in' to service mode with this SP before
you go into the printer SP mode.
001 CE Login
[Size Adjust]
5181
Adjusts the paper size for each tray.
001 TRAY 1
[0: OFF/ 1: ON]
*CTL 0: OFF (Detecte)
1: ON (Not Detecte)
*CTL [0: OFF/ 1: ON]
*CTL [0: Soft Key Set/ 1: Hard Key Set]
[0 or 1 / 0 / - ]
*CTL 0: Automatic printing
1: No automatic printing
[0 or 1 / 0 / - ]
*CTL 0: Disabled
1: Enabled
[0 to 3 / 0 (EU/ASIA), 1 (NA) / 1 /step]
*ENG
0: A4 LEF, 1: LT LEF, 2: B5 LEF, 3: A5 LEF
System Service Mode
8
299