Ricoh MPC 2800 AT-C2 Mode D'emploi page 607

Repeat Number: ACC
Specifies the maximum number of repeats of the toner density adjustment at ACC.
0: Disabled, 1 to 3: Repeat number,
004
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and toner is
consumed only when the toner density is too dark.)
6 to 9: Disabled
Repeat Number: Recovery
005
Not used
Repeat Number: Job End
Specifies the maximum number of repeats of the toner density adjustment at job end.
0: Disabled, 1 to 3: Repeat number,
006
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and toner is
consumed only when the toner density is too dark.)
6 to 9: Disabled
Repeat: Interrupt
007
Specifies the maximum number of repeats of the toner density adjustment during printing.
DFU
Toner Supply Coefficient
008
Adjusts the time for the toner supply mode when a toner density is detected to be low.
Consumption pattern: Bk
009
Specifies the belt mark generating time for checking the black toner density when toner
density is detected to be low at the toner density adjustment.
Consumption pattern: M
010
Specifies the belt mark generating time for checking the magenta toner density when toner
density is detected to be low at the toner density adjustment.
Consumption pattern: C
011
Specifies the belt mark generating time for checking the cyan toner density when toner density
is detected to be low at the toner density adjustment.
*ENG [0 to 9 / 3 / 1 time/step]
*ENG [0 to 9 / 0 / 1 time/step]
*ENG [0 to 9 / 4 / 1 time/step]
*ENG [0 to 9 / 0 / 1 time/step]
*ENG [0 to 25.5 / 10 / 0.1 sec/step]
*ENG [0 to 255 / 5 / 1 time/step]
*ENG [0 to 255 / 5 / 1 time/step]
*ENG [0 to 255 / 5 / 1 time/step]
System Service Mode
8
239