Ricoh MPC 2800 AT-C2 Mode D'emploi page 631

017 Refresh Threshold: Y
018 Pattern Generation Number: Bk
019 Pattern Generation Number: M
020 Pattern Generation Number: C
021 Pattern Generation Number: Y
022 Pattern Generation Number: Upper limit
023 Toner Consumption Pattern Area
024 Supply Coefficient
025 Job End Area Coefficient
026 Job End Vb Coefficient
027 Job End Length
028 Job End Supply
[Blade damage prevention mode]
Adjusts the threshold temperature for preventing the cleaning blade in the transfer belt
3517
cleaning unit from being damaged. If the temperature is above this value, toner is applied
to the transfer belt at set intervals during the job to prevent the blade from flipping over.
001 Execution Temp. Threshold
3518 [Image Quality Adj. Execution Flag] DFU
001 Toner End Recovery: Bk
002 Toner End Recovery: M
003 Toner End Recovery: C
004 Toner End Recovery: Y
005 Vsg Adj.
006 Developer Mixing
*ENG
*ENG
*ENG
*ENG [0 to 255 / 0 / 1 time/step]
*ENG
*ENG
[10 to 2550 / 300 / 10 cm
*ENG
step]
*ENG [0 to 2.55 / 1 / 0.01/step]
*ENG [0.1 to 25.5 / 1 / 0.1/step]
*ENG [0 to 100 / 40 / 1%/step]
*ENG [0 to 56 / 12 / 1mm/step]
[0 to 1 / 0.45 / 0.001 mg/cm
*ENG
step]
*ENG [0 to 50 / 40 / 1°C/step]
*ENG
*ENG
*ENG
[0 or 1 / 0 / 1/step]
0: OFF. 1: ON
*ENG
*ENG
*ENG
System Service Mode
2
/
2
/
8
263