Ricoh MPC 2800 AT-C2 Mode D'emploi page 650

8. Appendix: SP Mode Tables
Selects the contrast level for B/W the Text mode. Sets the erasure level of Irregular Dots. Set
higher for stronger effect, lower for weaker effect.
0: Not activated
4600 [SBU Version Display]
001 SBU_ID
002 GASBU-N_ID
003 VSP5100_ID
4602 [Scanner Memory Access]
001 Scanner Memory Access
002 Address Set
003 Data Set
4603 [AGC Execution]
8
001 HP Detection Enable
002 HP Detection Disable
4604 [FGATE Open/Close] DFU
001 -
4609 [Gray Balance Set: R]
001 Book Read
002 DF Read
282
[0 to 0xFF / - / 1 /step]
-
Displays the ID of the SBU.
- [0 to 0xFF / - / 1 /step]
- [0 to 0xFF / - / 1 /step]
Enables the read and write check for the SBU
-
registers.
-
Not used
-
- Executes the AGC.
- DFU
Opens or closes the FGATE signal. This SP
automatically returns to the default status (close)
after exiting this SP.
-
[0 or 1 / 0 / 1/step]
0: OFF, 1: ON
- [-512 to 511 / -46 / 1 digit/step]
- [-512 to 511 / -46 / 1 digit/step]