Ricoh MPC 2800 AT-C2 Mode D'emploi page 449

No. Type
The 1st failure issues an original jam message, and the 2nd failure issues this SC
code.
• Jogger HP sensor disconnected, defective
• Jogger motor disconnected, defective
• Jogger motor overloaded due to obstruction
• Finisher main board and jogger motor
1. Check the connections and cables for the components mentioned above.
2. Check for blockages in the jogger motor mechanism.
3. Replace the jogger HP sensor and/or jogger motor.
4. Replace the finisher main board.
No. Type
Stack feed-out motor error
• The stack feed-out HP sensor does not detect the home position of the stack
feed-out belt 3000ms after the stack feed-out belt has moved to its home
position.
• The stack feed-out HP sensor does not turn off 200 ms after the stack feed-out
belt has moved from its home position.
• The 1st detection failure causes a jam error, and the 2nd failure causes this SC
723 B
code.
• Defective stack feed-out HP sensor
• Overload on the stack feed-out motor
• Defective stack feed-out motor
• Defective main board
• Disconnected or defective harness
1. Check the connections and cables for the components mentioned above.
2. Check for blockages in the stack feed-out motor mechanism.
3. Replace the stack feed-out HP sensor and/or stack feed-out motor.
4. Replace the finisher main board.
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC Tables
3
81