Ricoh MPC 2800 AT-C2 Mode D'emploi page 519

Selects the rotation speed of the fusing idling.
1116 [Ends Temp. Correction]
Center Temp. 1: 226–
Specifies the temperature correction for the heating roller (center) when the paper width is
010
226 mm or more.
The start time of this SP can be adjusted with SP1116-018.
Ends Temp. 1: 226–
Specifies the temperature correction for the heating roller (ends) when the paper width is 226
011
mm or more.
The start time of this SP can be adjusted with SP1116-018.
Center Temp. 2: 226–
Specifies the temperature correction for the heating roller (center) when the paper width is
012
226 mm or more.
The start time of this SP can be adjusted with SP1116-019.
Ends Temp. 2: 226–
Specifies the temperature correction for the heating roller (ends) when the paper width is 226
013
mm or more.
The start time of this SP can be adjusted with SP1116-019.
Center Temp. 3: –226
Specifies the temperature correction for the heating roller (center) when the paper width is
014
less than 226 mm.
The start time of this SP can be adjusted with SP1116-020.
Ends Temp. 3: –226
Specifies the temperature correction for the heating roller (ends) when the paper width is less
015
than 226 mm.
The start time of this SP can be adjusted with SP1116-020.
Center Temp. 4: –226
016
Specifies the temperature correction for the heating roller (center) when the paper width is
less than 226 mm.
ENG [-10 to 10 / 5 / 1 deg/step]
ENG [-10 to 10 / 5 / 1 deg/step]
ENG [-10 to 10 / 0 / 1 deg/step]
ENG [-10 to 10 / 0 / 1 deg/step]
ENG [-10 to 10 / 5 / 1 deg/step]
ENG [-10 to 10 / -5 / 1 deg/step]
ENG [-10 to 10 / 0 / 1 deg/step]
System Service Mode
8
151