Ricoh MPC 2800 AT-C2 Mode D'emploi page 511

The machine does not feed paper until the temperature of the pressure roller reaches this
temperature if the machine is placed in the condition defiend by SP1104-001.
003 Idling Time: BW
004 Idling Time: FC
005 Idling Time: MiddleThick: BW
006 Idling Time: MiddleThick: FC
003 to
Specifies the idling time (waiting paper feed) for each print mode and paper type.
006
007 Pressure Temp: Paper Feed
008 Pressure Temp: Paper Feed: MT: BW
009 Pressure Temp: Paper Feed: MT: FC
007 to
Specifies the threshold temperature of the pressure roller for the paper feed.
009
Fusing Upper Limit Tem
010
Specifies the upper offset temperature to the fusing target temperature for the paper feed.
011 Offset: Feed Start
012 Offset: Feed Start: Middle Thick
011 to
Specifies the lower offset temperature to the fusing target temperature for the paper feed.
012
031 Offset: Feed Start: F
033 Offset: Feed Start: Glossy
031/
Specifies the upper offset temperature in 1200 dpi or glossy mode to the fusing target
temperature for the paper feed.
033
1bin: Paper Feed: Pressure Temp
040
Specifies the threshold of the pressure roller for the paper feed to the 1bin tray in 600 dpi
mode.
041 F :1bin: Paper Feed: Pressure Temp
*ENG
[0 to 10 / 0 / 1 sec/step]
*ENG
*ENG
[0 to 10 / 2 / 1 sec/step]
*ENG
*ENG
*ENG [0 to 130 / 50 / 1 deg/step]
*ENG
*ENG [0 to 100 / 15 / 1 deg/step]
*ENG [0 to 100 / 25 / 1 deg/step]
*ENG [0 to 100 / 10 / 1 deg/step]
*ENG
[0 to 100 / 15 / 1 deg/step]
*ENG
*ENG [0 to 100 / 85 / 1 deg/step]
*ENG [0 to 100 / 75 / 1 deg/step]
System Service Mode
8
143