Ricoh MPC 2800 AT-C2 Mode D'emploi page 453

No. Type
Finisher folder plate motor error
The folder plate moves but is not detected at the home position within the specified
time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC
code.
• Folder plate HP sensor disconnected, defective
• Folder plate motor disconnected, defective
761 B
• Folder plate motor overloaded due to obstruction.
1. Check the connections and cables for the folder plate motor and HP sensor.
2. Check for blockages in the folder plate motor mechanism.
3. Replace the folder plate HP sensor and/or folder plate motor
4. Replace the finisher main board.
No. Type
Punch movement motor error
The punch unit moves but is not detected at the home position within the specified
time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC
code.
763 B
• Motor harness disconnected, loose, defective
• Defective motor
1. Check the connections to the punch movement motor.
2. Defective punch movement motor
No. Type
Paper position sensor slide motor error
The paper position sensor moves but is not detected at the home position within the
specified time. The 1st detection failure issues a jam error, and the 2nd failure issues
this SC code.
764 B
• Motor harness disconnected, loose, defective
• Defective motor
1. Check the connections to the paper position sensor slide motor.
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC Tables
3
85