Ricoh MPC 2800 AT-C2 Mode D'emploi page 630

8. Appendix: SP Mode Tables
When the machine calculates the timing for process control, it uses a number of conditions.
These are the results after considering all the conditions.
001 Job End: Potential Control: BW
002 Job End: Potential Control: FC
003 Interrupt: Potential Control: BW
004 Interrupt: Potential Control: FC
[Refresh Mode] DFU
While making prints with low coverage, the developer is agitated with less toner consumption
3516
and the toner carrier attraction tends to increase. This may cause low image density or poor
transfer (white dots). To prevent this, the coagulated toner or overcharged toner has to be
consumed by performing the refresh mode.
001 Dev. Motor Rotation: Display: Bk
002 Dev. Motor Rotation: Display: M
003 Dev. Motor Rotation: Display: C
004 Dev. Motor Rotation: Display: Y
8
005 Rotation Threshold
006 Pixel Coverage Sum: Bk
007 Pixel Coverage Sum: M
008 Pixel Coverage Sum: C
009 Pixel Coverage Sum: Y
010 Required Area: Bk
011 Required Area: M
012 Required Area: C
013 Required Area: Y
014 Refresh Threshold: Bk
015 Refresh Threshold: M
016 Refresh Threshold: C
262
*ENG [0 to 2000 / 500 / 1 page/step]
*ENG [0 to 2000 / 200 / 1 page/step]
*ENG [0 to 2000 / 500 / 1 page/step]
*ENG [0 to 2000 / 200 / 1 page/step]
*ENG
*ENG
[0 to 1000 / 0 / 0.1 m/step]
*ENG
*ENG
*ENG [0 to 1000 / 1 / 1 m/step]
*ENG
*ENG
*ENG
*ENG
[0 to 65535 / 0 / 1 cm
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG
[0 to 255 / 14 / 1 cm
*ENG
2
/step]
2
/m/step]